1991 964 Targa/Cabriolet Passenger Door . With Loom, and Window Regulator

For sale is a passenger door from a 1991 964 Targa/Cabriolet

Includes Window glass, Loom and window regulator

We have different Colors also

Are the doors from a 993 the exact same as from say a 3.2 Carrera?

No

Are they similar or are they exact part numbers?

? Can't understand the sense of that question.

Do coupe doors differ from targa and cab doors?

Yes, slightly. The Targa/Convertible have a small piece of Sheetmetal welded into the window channel ends to avoid a visible gap. Otherwise identical to Coupe.

Are the '98 model year the 911 doors the only unchanged body pant-s. Is this down to the part number or do they mean visually identical?

The general shape ( the outer skin) is the same from 65-98 but the inner structure changed several times.

The inner door skin changed in these phases

65-68 the rear from the door has a raised area where the door lock sits.

69-79 flat rear end and some holes with sliding flat nuts for the door pockets. one hole more for the wire loom.

The door stop area is changed.

71- the mounting screws for the rear lock changed from M5 to M6 needing a deeper recces

73- US only, reinforcement beam, big hole the alarm

77- relocation from the mirror holes and one more hole for wire loom (mirror ) again. The sliding nuts where removed, the door pockets use plastic anchors for the screws.

80- reinforcement beam standard ROW, more holes for new window system reinforced door stop area.

B5-89 The two holes for the upper frame mount in the rear changed to a long cutout. The upper front end was changed, the recessed area helps the mirror switch a support brace will hold the upper cover. The door will now carry a two speaker system and the door pockets where slightly shorter, the front end so the front is screwed direct to the skin and not indirect via the little plastic cube. The backend has two little holes for the internal door mechanism cover. The door locks are mounted with reinforcement washers. The rear door pocket anchor area is reinforced from the backside

89-94 (964) big hole on the frontend to run the new wire loom

94-98 (993) big hole on the underside for the windowtrap mounting. Some additional holes for internals.

Porsche always replaced the stocks with newer doors so you always had to modify the new doors to the old versions or just bolt it up as it is.

The 993 doors will fit into the 65 body and all the holes are in it or marked to be drilled up.

If you use a 89 or door the interior light switch will need modification.

fitting a 65 door into a 993 is big work.